Xerox 4112-4127 Enterprise Printing System-4612 - Manual (Page 196)

Addendum
9-20 Xerox 4112/4127 EPS
User Guide
Jam clearance
If a jam occurs, the machine stops printing and a message is displayed on the User Interface
(UI). Follow all instructions displayed completely and in the sequence shown.
Interface Module jams
Perform the following steps to clear the Interface Module jam and resume printing:
1. Open the Interface Module Front Cover.
2. Lift the green handles and/or rotate the green knob and remove all jammed paper and paper scraps.
3. Close the Interface Module Front Cover.
4. If the UI indicates there is a jam in the digital press, follow the instructions on the screen to remove
any paper in the area indicates. Refer to the Jam Clearance section in the Problem Solving chapter in
this manual.
5. Follow the instructions displayed on the digital press UI to resume printing.
Basic troubleshooting
When a problem occurs with your Interface Module, instructions may appear on the UI; refer to
the information in this section to help resolve the problem.
The fault code table, which starts on the following page, lists problems and suggested solutions
that apply to the Interface Module. If the problem persists after following all instructions, call
your Xerox representative.