Xerox 4112-4127 Enterprise Printing System-4612 - Manual (Page 122)

Problem Solving
7-20 Xerox 4112/4127 EPS
User Guide
116-714 P Cause: An HP-GL/2 command error occurred.
Remedy: Check the print data.
116-720 P Cause: An error occurred during printing as there was
insufficient memory.
Remedy: Stop unnecessary ports and remove unnecessary
data from the hard disk to increase free disk space.
116-740 P Cause: Numerical value operation error occurred as a value
exceeding the value limit of the printer was used in the print
data.
Remedy: Check the print data.
116-747 P Cause: There are too many paper margin values for the
HP-GL/2 effective coordinate area.
Remedy: Reduce the paper margin values, and instruct it to
print again.
116-748 P Cause: There is no plot data in the HP-GL/2 print data.
Remedy: Check the print data.
116-749 P Cause: Job cancelled because the specified font was
unavailable.
Remedy: Install the font or set up a font replacement on the
print driver side.
116-771
116-772
116-773
116-774
116-775
116-776
116-777
116-778
116-790 P Cause: There was a problem with parameters in the JBIG
data. They were automatically edited.
Remedy: If any problem occurs in job result, try to process
the job again.
123-400 P Cause: A malfunction occurred in the machine.
Remedy: Power-cycle the machine. If the machine error is
not fixed by performing the relevant remedy, contact the
Customer Support Center.
127-210 P, O Cause: Communication error between the printer and the
FreeFlow Print Services Controller. Error detected by the
printer.
Remedy: Remove and reinsert the cable connection between
the printer and the FreeFlow Print Services Controller. Power
off and on both the printer and the FreeFlow Print Services
Controller. If the problem persists, call the Customer Support
Center.
127-211 P, O Cause: Detected a communication error between the printer
and the FreeFlow Print Services Controller.
Remedy: Remove and reinsert the cable connection between
the printer and the FreeFlow Print Services Controller. Power
off and on both the printer and the FreeFlow Print Services
Controller. If the problem persists, call the Customer Support
Center.
Error Code
Category
Cause and Remedy
Print/Other