Konica Minolta Magicolor 7300 - Manual (Page 33)

Loading Media 25
4
Align the edges of up to 250 sheets of paper, and then load it face up.
If the media is curled, flatten it before loading it.
Often, an arrow on the media
package label indicates the
face-up (print) side of the media.
If you’re loading letterhead, load
the letterhead or logo side
oriented toward the front of the
tray.
Do not load media above the
media limit mark.
5
Slide the media guides against the
edges of the media.
Attention
Always adjust the media guides
after inserting media. Guides that
are not properly adjusted can cause
poor print quality, media jams, or
printer damage.
6
Close Tray 1.
7
In the printer driver, select Plain Paper and the appropriate media size.
If you’re using custom-size media, set the printer for custom-sized
media in the printer driver.
8
Print the job.
Envelopes
Print on the envelope front (address side) only. Some parts of the envelope
consist of three layers of paper—the front, back, and flap. Anything printed in
these layered regions may be lost or faded.
1
Flex a stack (including the edges) of up to 50 envelopes to remove any
stiffness.
2
Correct any bent corners, and then tap the envelopes on a flat surface to
align them.
3
Place the envelopes on a flat surface, and press them down to flatten
them and make sure that all air is removed.
Make sure that the folds of the flaps are firmly pressed; otherwise, the
envelopes may become wrinkled or a media jam may occur.