Introduction, Introduction 122 – Konica Minolta Magicolor 7300 User Manual
Page 130
Introduction
122
Introduction
How do I handle the printer?
Attention
Read all caution and warning labels carefully, making sure to follow any
instructions contained in them. These labels are located on the inside of
the printer’s doors and the interior of the printer body.
Handle the printer with care to preserve its life. Abuse may cause damage
and void your warranty.
Attention
Do not open any cover of the printer during printing.
Do not tilt the printer more than ±1% in any direction.
For best output quality and longest consumables life, keep the
printer on a hard, flat, level surface. A surface can be tested for
levelness with a standard round pencil. If the pencil rolls, the
surface is not level.
Avoid the accumulation of dust and paper debris.
Always close the printer doors gently. Never expose the printer to
vibrations.
Be careful when removing paper jams, as the fuser and other internal
parts may become very hot.
Do not cover the printer immediately after using it.
Turn it off and wait until it cools down.
Do not leave the printer’s covers and doors open for any length of time,
especially in well-lit places; light may damage the print units.
Do not tap paper stacks on the printer.
Do not tilt, oil, lubricate, or disassemble the printer.
Do not touch the electrical contacts, gears, or laser beam devices. Doing
so may damage the printer and cause the print quality to deteriorate.
Do not load media above the
media limit mark.
How do I handle the printer?
When does the printer need cleaning?