Konica Minolta Magicolor 7300 - Manual (Page 204)

Solving Problems 196
You hear
unusual
noises. The printer is not on a
level enough surface. Put the printer on a flat, hard, level
surface (not exceeding ±1° slant at any
point around the machine).
The media tray is not
installed correctly. Remove the media tray that you are
printing from and reinsert it completely
into the printer.
There is a foreign
object stuck inside
the printer. Turn off the printer and remove the
object. If you cannot remove it, contact
Technical Support. See the Service &
Support Guide for a list of sources of
service and support for many areas of
the world. For the most up-to-date
information globally, check
www.konicaminolta.net/printer/.
Media is
wrinkled. The media is moist
from humidity or
having water spilled
on the paper supply. Remove the moist media and replace it
with new, dry media.
Unsupported media
is being used. Use KONICA MINOLTA-approved
media. See “Media Types” on page 15.
Check printer.konicaminolta.net/
support (click on “Answer Base”) for
currently approved media.
Symptom Cause Solution