Warning – Konica Minolta Magicolor 7300 User Manual
Page 125
Replacing Media Pickup and Separator Rollers
117
How do I replace the media separator roller for Tray 1?
The following procedure describes the replacement of the media separator
roller for Tray 1.
1
Remove the two screws from the
outer-right side of the tray, as
shown, and then remove the media
separator roller.
The media separator roller is
attached to the two reinforcing
plates on the opposite side of
the screws. When the screws
are removed, the reinforcing
plates will fall. Therefore, catch
the reinforcing plates with your
hand when removing the
screws.
2
Take out the new media separator roller.
Place the used media separator roller in the packing for the new
media separator roller.
Do not throw away the box and plastic bag that the new media
separator roller was packed in.
They will be reused to pack the used media separator roller.
WARNING!
3
Attach the new media separator
roller to the tray.
Before tightening the screws, be
sure that the pins on the rein-
forcing plates are toward the
back of the tray.
4
Close the tray.
Dispose of the used media separator roller in accordance with local
re
regulations.