Konica Minolta Magicolor 7300 - Manual (Page 214)

Control Panel Messages 206
TRAY TYPE ERR
ADD MEDIA
The transparency
sensor detects the
tray (
TRAY ) has
transparency media,
but the driver
selection is not
Transparency, or the
tray has other media
(
MEDIA ) than
transparency, but the
driver selection is
Transparency.
Install MEDIA (media
type) and make sure
driver is set correctly.
Remove and insert the
tray before resuming
printing.
COVER OPEN
CHECK Y
Printer’s door (Y) is
open and must be
closed. Close the specified door.
FUSER LOW The fuser is nearing
the end of its life. Replace the fuser.
FUSER MISSING
CHECK UNIT
The fuser is missing
or is not correctly
installed. Open the side door and
make sure the fuser has
been installed. If
necessary, install the
fuser unit and close the
side door.
MANL FEED ERROR
REMOVE MEDIA
Media is inserted in
the manual feed tray
during duplex printing
from another tray. Remove the media in
the manual feed tray.
MEDIA EMPTY
ADD X
The tray is out of
media size (
X) .
Install the specified
media size into any tray.
MEDIA JAM
Y
There is a media jam
in the specified
location (
Y) .
Locate and remove the
jam.
This message... means... do this...