Konica Minolta Magicolor 7300 - Manual (Page 225)

Requirements 217
Power Requirements
WARNING!
Connect the power plug to an outlet with the same rated voltage as the
printer. No other devices should be connected to this outlet, as
overheating could cause fire or electric shock. The printer draws 14 A at
100 V, 12 A at 120 V, or 6.5 A at 220–240 V. Your printer requires a
properly grounded AC outlet. The grounding terminal on the power
cable should be connected to a good earth ground to prevent electric
shock and fire.
Input Power Japan 100 VAC ±10%; 50/60 Hz ±3%
North America 120 VAC ±10%; 50/60 Hz ±3%
Europe 220–240 VAC ±10%; 50/60 Hz ±3%
Latin America 120 VAC ±10%; 50/60 Hz ±3%
220–240 VAC ±10%; 50/60 Hz ±3%
Notes: Amperage capacity is at least 1.2 times that used
by the printer.
Voltage
Fluctuation
Rate and Rated
Line Voltage Japan 100 VAC ±10%
North America 120 VAC ±10%
Europe 220–240 VAC ±10%
Latin America 120 VAC ±10%
220–240 VAC ±10%
Notes: 10% of the rated line voltage for proper operation.
Frequency
Variation Rate Within 50–60 ±3 Hz
Maximum
Electrical
Current Required during operation is 14 amps for a 100 V system,
12 amps for a 120 V system and 6.5 amps for a 220–240 V
system.
Noise-
generating
Equipment Should not be connected to the same electrical outlet as
the printer.
Grounding Your printer requires a properly grounded AC outlet.
Notes: In compliance with UL guidelines, “The appliance inlet is
considered to be the main disconnect device.”