Konica Minolta Magicolor 7300 - Manual (Page 170)

Lower Feeder Units (Trays 3 and 4) 162
22
Secure the harness with the cable
holders so that the core is between the
holders on Tray 3’s unit.
23
Loop the harness once, and then secure
it with the cable holder on Tray 2’s unit.
Secure the harness in front of the
connectors and so they do not interfere
with the core.
24
Plug the black 3-pin connector of
another power supply harness B (with
no core attached) into a connector at
the back of the printer.
The 3-pin connector (black
socket) can be plugged into any
of the three connectors on the
printer. As an example, the
illustration at the right shows the
connector plugged into the
upper-right connector.