Konica Minolta Magicolor 7300 - Manual (Page 118)

Replacing the Fuser Unit 110
Close the right-side door with
the tags on the shipping brack-
ets protruding from the door.
If the printer is to be used
again, be sure to remove the
shipping brackets before use.
If the shipping brackets were
lost, lower the fuser levers
to their lowest positions
before closing the right-side
door. Before using the printer
again, return the fuser levers
to their original positions.
Attention
If the printer is used without
the fuser levers returned to
their original positions,
decreased image fusing may
result.
5
Close the right-side door.
6
Place the used fuser unit, which was removed, into the packaging for the
new fuser unit.
Left side
Right side