Konica Minolta Magicolor 7300 - Manual (Page 116)

Replacing the Fuser Unit 108
4
Firmly grab the fuser unit with
both hands, and then pull it out
toward you to remove it.
Attention
Dispose of the used fuser unit in accordance with local regulations.
Installing a New Fuser Unit
1
Remove the new fuser unit from its box, and then remove the packing
material and packing tape, except the shipping brackets.
2
Holding the fuser unit with both
hands, fully insert it in the printer.
3
Tighten the two shoulder screws,
one on each side.