Konica Minolta Magicolor 7300 - Manual (Page 187)

Clearing Media Jams 179
12
Close the right-side door.
If the manual feed tray was removed
in step 3, reinstall it.
Clearing Media Input Jams
Error messages:
MEDIA JAM/TRAY1
MEDIA JAM/TRAY2
MEDIA JAM/TRAY3
MEDIA JAM/TRAY4
MEDIA JAM/MANUAL TRAY
Attention
The image is not fixed on the media before the fusing process. If you
touch the printed surface, the toner may stick to your hands, so be
careful not to touch the print face when removing the jammed media.
Make sure not to spill any toner inside the printer.
Unfused toner can dirty your hands, clothes, or anything else it gets on.
If you accidentally get toner on your clothes, lightly dust them off as
much as possible. If some toner remains on your clothes, use cool, not
hot water, to rinse the toner off. If toner gets on your skin, wash it off
with water and a neutral detergent.
WARNING!
If toner gets in your eyes, immediately flush them with water, and then
seek medical attention. Material Safety Data Sheet (MSDS) information
can be found
at printer.konicaminolta.net/support (cli ck on “Answer
Base”).
If, after clearing the media jam, the jam message in the control panel
message window persists, open and close the printer’s front and right-side
doors. This should clear the jam message.