Konica Minolta bizhub PRESS C1060 User Manual
Page 41
that the device can measure each separation and find the
point at which the toner appears on the paper.
10. Perform the following steps for each separation on the
calibration chart (cyan, magenta, yellow, and black).
a. Press and hold the button on the side of the I1, and align
the I1s head with the arrow tip of the color separation row
you are scanning. The arrow is to the left of the color
separation row on the calibration chart. Its tip intersects the
semi-dotted line.
b. Sweep the i1 spectrophotometer across the color
separation row.
When you reach the end of the row, if the scan is
successful, a check mark
appears in the wizard above
the icon of the color you have just scanned, and an arrow
appears below the icon of the next color to scan. The
instructions in the wizard change according to the next
color to be scanned.
If the scan is not successful a red and white icon
appears above the color you have just scanned indicating
that the scan was not successful and that you should re-
scan that row.
Creating calibration tables with the X-Rite i1/i1iO/iSis spectrophotometer
31