Konica Minolta bizhub PRESS C1060 - Manual (Page 191)

Parameter Option Description
First Mark
Position
Note: This option is available only when the signature mark mode is
set to Custom.
Enables you to specify the position of the first signature mark.
Mark Offset
Note: This option is available only when the signature mark mode is
set to Custom.
Enables you to specify the offset between signature marks.
Black Color Enables you to determine the amount of black toner used for printing
signature marks.
Spacing Margins Determines the space between the edge of the pages and the edge
of the sheet on which the pages are printed.
Notes:
● Margin settings should suit the finishing equipment and
requirements.
● Confirm the binding parameters with your binder when planning
your sheet.
Horizontal
gutter Determines the horizontal space between pairs of pages (according
to the trim size) on a sheet. When the pages are folded into a
booklet, the gutter allows space for trimming.
The value that you enter depends on the paper size and imposition
method that you choose.
Vertical gutter Determines the vertical space between pairs of pages (according to
the trim size) on a sheet. When the pages are folded into a booklet,
the gutter allows space for trimming.
The value that you enter depends on the paper size and imposition
method that you choose.
Spine
Note: This option is available only when the imposition method is set
to Perfect Bound.
Determines where the signatures are joined at the center fold and
then stitched or bound.
The value that you enter depends on the paper size that you choose.
Imposition tab in the job parameters window 181