Konica Minolta bizhub PRO 1051 - Manual (Page 291)

Troubleshooting 11
bizhub PRO 1200/1200P/1051 Printer 11-3
3
Try to make a copy.
– When copying is available, go to Step 4.
4
Turn off the copier and wait for 10 seconds, then restart it. Print the test
print again after the image controller is ready.
– Contact your Konica Minolta service representative if you cannot
print the test page after performing the above procedures.
The print setting of a job does not correspond to the result of printing.
1
Check that the printer setting was not changed.
Cannot select [2-Sided]
1
In the case of the PCL printer driver, click [Default] of the [Basic] tab
and [Layout] tab, and return to the state of default.
2
Check that any item other than [Custom Size] or [Japanese Post Card]
is selected in [Output Tray]
3
Check that [Plain Paper] is selected in the [Paper Type].
4
In the case of the PCL printer driver, check that the [Print Type] setting
is not [Booklet].