Festo Электромотор MTR-DCI - Manual (Page 70)

4. Control panel (MTR-DCI-...-H2IO)
4-12
Festo P.BE-MTR-DCI-IO-EN en 1209d
[Axis param] Teach mode for setting the axis parameters
[Axis param] Description
[Zero point] Offset of axis zero point
[Abs.min.pos] Stroke limitation: Software limit switch,
negative
[Abs.max.pos] Stroke limitation: Software limit switch,
positive
[Save...] Save parameter in EEPROM
Note
The set parameters become effective immediately after
confirmation with OK . The settings are saved per-
manently in EEPROM with the menu command [Save...] :
• Save the parameter settings with the menu command
[Save]. Only then will the settings be retained even if the
power supply is switched off or if there is a power
failure.