Festo Электромотор MTR-DCI - Manual (Page 15)

Contents and general instructions
XIII Festo P.BE-MTR-DCI-IO-EN en 1209d
Information on the version
The hardware version specifies the version status of the
mechanical parts and electronics of the MTR-DCI. The firm-
ware version specifies the version status of the operating
system of the MTR-DCI.
You can find the specifications on the version status as
follows:
– Hardware version and firmware version in the Festo
Configuration Tool with active device connection to the
MTR-DCI under “Device data”
– Firmware version on the control panel under [Diagnostic]
[Software information]
Firmware
version What is new ? Which FCT PlugIn ?
V-DME1.19 Supports the motor sizes MTR-DCI-42 and 52 and the
combination with the following positioning axes from
Festo:
Motor unit
Axis
MTR-DCI-42 DMES-25
MTR-DCI-52 DMES-40
MTR-DCI V1.0.0
V1.20 – Supports the motor sizes MTR-DCI-32 and 62 and
the combination with the following positioning
axes from Festo:
Motor unit
Axis
MTR-DCI-32 DMES-18
MTR-DCI-42 DMES-25
MTR-DCI-52 DMES-40
MTR-DCI-62 DMES-63
– Modifying the start-up reaction of all sizes
MTR-DCI V1.1.0
V1.35 – Function “Save position when switching off” re-
moved.
The CI-parameter 60FB
h , subindex 20 h , contains
the fixed value 240 (0x00F0) and cannot be over-
written, see appendix B.1.4.
MTR-DCI V2.1.1.4
Tab. 0/2: Firmware versions