Festo Электромотор MTR-DCI - Manual (Page 23)

1. System summary
1-5 Festo P.BE-MTR-DCI-IO-EN en 1209d
All parameters are entered or displayed in the relevant set
measuring units.
Units of Measurement Control
panel FCT
Linear axis Metric Metric units of measurement,
e.g. mm, mm/s, mm/s
2
x x
Customs du-
ties
1)
Imperial units of measurement,
e.g. inch, inch/s, inch/s
2
– x
Increments Increment-based units of measurement,
e.g. inc, inc/s, inc/s
2
– –
Rotation axis Degree Angle dimension
360° = 1 revolution
e.g. deg, deg/s, deg/s
2
x x
Revolutions
2)
Number of revolutions
e.g. rev, rev/min, rev/min
2
x –
Increments Increment-based units of measurement,
e.g. inc, inc/s, inc/s
2
– –
1)
Only with FCT when creating a project.
2)
Setting only with the control panel [Settings] [Axis type] [Rotation axis]
Tab. 1/2: Units of Measurement
Setting the units of measurement influences only the dis-
play. All the parameters in the controller are saved internally
in increments (inc, inc/s, inc/s
2
...) and are not converted until
they are written or read.
Measurements transmitted directly via RS232 are conducted
on an increment basis (for conversion see appendix A.4).