Pulsafeeder Pulsar DLCM - Manual (Page 97)

91
10. Factory Default Values
CALIBRATION
Pump Flow
1-Point Calibration on PULSAR at Rated Flow and Pressure.
Analog Input 4.0 - 20.0mA @ 100% Ratio
Analog Output 4.0 - 20.0mA @ 100% Ratio
DIAGNOSTICS
Alarms
Cleared
DATE/TIME
Date Format
MM/DD/YY
Time Format 24:00
Daylight Savings Time No
ANALOG INPUT Enabled – Number of input channels enabled is one.
Failure Mode channel #n Freeze at last signal / Restore to Analog Mode/ Error message enabled
Sample Average channel #n 20 Samples
Sample Update channel #n 20 Samples (5.0 Seconds)
ANALOG OUTPUT
Stroke and Speed setting
Calibrated Stroke and Speed combined
END POINT & PRIORITY
Stroke Minimum
0%
Stroke Maximum 100%
Speed Minimum 10%
Speed Maximum 100%
Priority Speed
LEAK DETECTION
Failure Mode
Inactive
LEVEL INPUT
Failure Mode
Inactive
DIGITAL OUTPUT
Run/Stop
Normally Open
MOTOR THERMOSTAT
Input
Enabled
Switch Normally Closed
Motor Off
Alarm
Restore to: On
Motor On
OVER TEMPERATURE
Error Message
Enabled
POWER FAILURE
Failure Mode
During power up – Motor Off
Wrong Voltage Hard Shutdown
ALARM RELAY
Relay Output
Normally Open
SECURITY Remains as previously set