Pulsafeeder Pulsar DLCM - Manual (Page 28)

22
6. Start Up Instructions
6.1 Overview
Once all electrical connections have been made, your DLCM is ready for Start-up. The following nine
sections detail the procedures required to complete a DLCM start up.
W
HEN POWER IS SUPPLIED TO THE UNIT
,
LINE VOLTAGE IS PRESENT ON THE
F
IELD
W
IRING
B
OARD LOCATED AT THE BACK OF THE UNIT EVEN WHEN THE
M
OTOR IS
OFF.
D
URING
S
TART
-
UP
,
IT IS NECESSARY TO RUN THE PUMP MOTOR
. T
HIS WILL CAUSE FLUID TO
DISCHARGE FROM THE PUMP . Y OU ARE RESPONSIBLE FOR SAFELY DIVERTING FLOW FROM THE
PUMP DURING START
-
UP AND CALIBRATION
.
6.1.1 User Interface Familiarization.
There are four key elements that will be useful in starting-up the DLCM:
a) Display
b) Keypad
c) Manual Adjustment Knob
d) Pump Motor.
Refer to Figure 12 to familiarize yourself with the location of these items before proceeding.
Figure 12. – Key DLCM start-up elements.