Pulsafeeder Pulsar DLCM - Manual (Page 111)

105
Figure 25 – DLCM/Eccentric mating components
7. Locate the face on the bottom of the DLCM that mates with the face of the lip of the eccentric box.
The DLCM is oriented such that the control pad and display sit to the left of the pump's reagent head
(as viewed standing in front of the reagent head looking at the motor). The conduit connections and
access panel (with Serial Tag) reside at the rear of the pump near the gear box.
8. Orient the DLCM properly at a comfortable height above the pump and align the slot in the DLCM
coupling with the 'flats' on the adjustment shaft by turning the black hand knob on the DLCM. Do not
turn the adjustment shaft!
9. Lower the DLCM onto the eccentric box. It may be necessary to tip the DLCM slightly towards the
motor to clear the motor adapter. With the DLCM approximately 25mm (1 inch) above the eccentric
box, make a fine adjustment to align the slot in the DLCM coupling with the adjustment shaft 'flats'.
Once aligned, lower the DLCM to mate with the eccentric box. Do not force the cover! When the
coupling is properly aligned, the DLCM will seat properly under its own weight.
10. Install the 4 DLCM mounting screws and washers provided.
11. Remove the 4 wiring access panel screws.
12. Follow the instructions in Section 5 – Installation: Electrical Wiring of this manual for electrical
connections.
13. Perform the steps detailed in Section 6 – Start Up Instructions.
14. Review Section 7 – General Operation for detailed information on configuring your DLCM and its
advanced features.