beautypg.com

Cluster ip-pool, Cluster member – Accton Technology Edge-corE Fast Ethernet Switch ES3528M-SFP User Manual

Page 622

background image

Command Line Interface

4-326

4

cluster ip-pool

This command sets the cluster IP address pool. Use the no form to reset to the
default address.

Syntax

cluster ip-pool <ip-address>
no cluster ip-pool

ip-address - The base IP address for IP addresses assigned to cluster
Members. The IP address must start 10.x.x.x.

Default Setting

10.254.254.1

Command Mode

Global Configuration

Command Usage

• An “internal” IP address pool is used to assign IP addresses to Member

switches in the cluster. Internal cluster IP addresses are in the form
10.x.x.member-ID. Only the base IP address of the pool needs to be set since
Member IDs can only be between 1 and 36.

Set a Cluster IP Pool that does not conflict with addresses in the network IP
subnet. Cluster IP addresses are assigned to switches when they become
Members and are used for communication between Member switches and the
Commander

.

• You cannot change the cluster IP pool when the switch is currently in Commander

mode. Commander mode must first be disabled.

Example

cluster member

This command configures a Candidate switch as a cluster Member. Use the no form
to remove a Member switch from the cluster.

Syntax

cluster member mac-address <mac-address> id <member-id>
no cluster member id <member-id>

mac-address - The MAC address of the Candidate switch.

member-id - The ID number to assign to the Member switch.
(Range: 1-36)

Default Setting

No Members

Command Mode

Global Configuration

Console(config)#cluster ip-pool 10.2.3.4
Console(config)#