beautypg.com

Dot1x intrusion-action, Show dot1x – Accton Technology Edge-corE Fast Ethernet Switch ES3528M-SFP User Manual

Page 414

background image

Command Line Interface

4-118

4

dot1x intrusion-action

This command sets the port’s response to a failed authentication, either to block all
traffic, or to assign all traffic for the port to a guest VLAN. Use the no form to reset
the default.

Syntax

dot1x intrusion-action {block-traffic | guest-vlan}
no dot1x intrusion-action

Default

block-traffic

Command Mode

Interface Configuration

Command Usage

For guest VLAN assignment to be successful, the VLAN must be configured
and set as active (“vlan database” on page 4-242) and assigned as the guest
VLAN for the port (“network-access guest-vlan” on page 4-125).

Example

show dot1x

This command shows general port authentication related settings on the switch or a
specific interface.

Syntax

show dot1x [statistics] [interface interface]

statistics - Displays dot1x status for each port.
• interface

ethernet unit/port

- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-28)

Command Mode

Privileged Exec

Command Usage

This command displays the following information:

Global 802.1X Parameters – Shows whether or not 802.1X port

authentication is globally enabled on the switch.

802.1X Port Summary – Displays the port access control parameters for

each interface, including the following items:

Console(config)#interface eth 1/2
Console(config-if)#dot1x intrusion-action guest-vlan
Console(config-if)#