Show ip dhcp snooping binding, Ip cluster commands, Cluster – Accton Technology Edge-corE Fast Ethernet Switch ES3528M-SFP User Manual
Page 620: Cluster 4-324, Table 4-86, Switch cluster commands

Command Line Interface
4-324
4
show ip dhcp snooping binding
This command shows the DHCP snooping binding table entries.
Command Mode
Privileged Exec
Example
IP Cluster Commands
IP Clustering is a method of grouping switches together to enable centralized
management through a single unit. A switch cluster has a “Commander” unit that is
used to manage all other “Member” switches in the cluster. The management station
uses Telnet to communicate directly with the Commander throught its IP address,
and the Commander manages Member switches using cluster “internal” IP
addresses. There can be up to 36 Member switches in one cluster. Cluster switches
are limited to within a single IP subnet.
cluster
This command enables clustering on the switch. Use the no form to disable
clustering.
Syntax
[no] cluster
Default Setting
Enabled
Command Mode
Global Configuration
Console#show ip dhcp snooping binding
MacAddress IpAddress Lease(sec) Type VLAN Interface
----------------- --------------- ---------- -------------------- ---- ---------
11-22-33-44-55-66 192.168.0.99 0 Static 1 Eth 1/5
Console#
Table 4-86 Switch Cluster Commands
Command
Function
Mode
Page
cluster
Configures clustering on the switch
GC
cluster commander
Configures the switch as a cluster Commander
GC
cluster ip-pool
Sets the cluster IP address pool for Members
GC
cluster member
Sets Candidate switches as cluster members
GC
rcommand
Provides configuration access to Member switches
GC
show cluster
Displays the switch clustering status
PE
show cluster members
Displays current cluster Members
PE
show cluster candidates Displays current cluster Candidates in the network
PE