Accton Technology Edge-corE Fast Ethernet Switch ES3528M-SFP - Manual (Page 244)

Configuring the Switch
3-194
3
Web – Click Priority, Traffic Classes. The current mapping of CoS values to output
queues is displayed. Assign priorities to the traffic classes (i.e., output queues),
then click Apply.
Figure 3-118 Traffic Classes
CLI – The following example shows how to change the CoS assignments.
* Mapping specific values for CoS priorities is implemented as an interface configuration
command, but any changes will apply to the all interfaces on the switch.
Enabling CoS
Enable or disable Class of Service (CoS). Command Attributes
• Traffic Classes – Click to enable Class of Service. (Default: Enabled)
Console(config)#interface ethernet 1/1 4-166
Console(config-if)#queue cos-map 0 0 4-267
Console(config-if)#queue cos-map 1 1
Console(config-if)#queue cos-map 2 2
Console(config-if)#end
Console#show queue cos-map ethernet 1/1
4-269
Information of Eth 1/1
CoS Value: 0 1 2 3 4 5 6 7
Priority Queue: 0 1 2 1 2 2 3 3
Console#