beautypg.com

Link aggregation commands, Table 4-51 – Accton Technology Edge-corE Fast Ethernet Switch ES3528M-SFP User Manual

Page 476

background image

Command Line Interface

4-180

4

Link Aggregation Commands

Ports can be statically grouped into an aggregate link (i.e., trunk) to increase the
bandwidth of a network connection or to ensure fault recovery. Or you can use the
Link Aggregation Control Protocol (LACP) to automatically negotiate a trunk link
between this switch and another network device. For static trunks, the switches have
to comply with the Cisco EtherChannel standard. For dynamic trunks, the switches
have to comply with LACP. This switch supports up to four trunks. For example, a
trunk consisting of two 1000 Mbps ports can support an aggregate bandwidth of
4 Gbps when operating at full duplex.

Table 4-51 Link Aggregation Commands

Command

Function

Mode

Page

Manual Configuration Commands
interface port-channel

Configures a trunk and enters interface

configuration mode for the trunk

GC

4-166

channel-group

Adds a port to a trunk

IC (Ethernet)

4-181

Dynamic Configuration Command
lacp

Configures LACP for the current interface

IC (Ethernet)

4-182

lacp system-priority

Configures a port's LACP system priority

IC (Ethernet)

4-183

lacp admin-key

Configures a port's administration key

IC (Ethernet)

4-184

lacp admin-key

Configures an port channel’s administration key IC (Port Channel)

4-185

lacp port-priority

Configures a port's LACP port priority

IC (Ethernet)

4-186

Trunk Status Display Command
show interfaces status

port-channel

Shows trunk information

NE, PE

4-173

show lacp

Shows LACP information

PE

4-186