Accton Technology Edge-corE Fast Ethernet Switch ES3528M-SFP - Manual (Page 462)

Command Line Interface
4-166
4
Interface Commands
These commands are used to display or set communication parameters for an
Ethernet port, aggregated link, or VLAN.
interface
This command configures an interface type and enters interface configuration mode.
Use the no form to remove a trunk.
Syntax
interface interface
no interface port-channel channel-id
interface
• ethernet unit/port
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-28)
• port-channel channel-id (Range: 1-8)
• vlan vlan-id (Range: 1-4092)
Default Setting
None
Command Mode
Global Configuration
Table 4-47 Interface Commands
Command Function Mode Page
interface Configures an interface type and enters interface configuration
mode
GC 4-166
description Adds a description to an interface configuration IC 4-167
speed-duplex Configures the speed and duplex operation of a given interface
when autonegotiation is disabled
IC 4-167
negotiation Enables autonegotiation of a given interface IC 4-168
capabilities Advertises the capabilities of a given interface for use in
autonegotiation
IC 4-169
flowcontrol Enables flow control on a given interface IC 4-170
shutdown Disables an interface IC 4-171
switchport packet-rate Configures the broadcast storm control threshold IC 4-172
clear counters Clears statistics on an interface PE 4-172
show interfaces status Displays status for the specified interface NE, PE 4-173
show interfaces
counters
Displays statistics for the specified interfaces NE, PE 4-174
show interfaces
switchport
Displays the administrative and operational status of an
interface
NE, PE 4-175