Accton Technology Edge-corE Fast Ethernet Switch ES3528M-SFP - Manual (Page 491)

LLDP Commands
4-195
4
lldp
This command enables LLDP globally on the switch. Use the no form to disable
LLDP.
Syntax
[no] lldp
Default Setting
Enabled
Command Mode
Global Configuration
Example
lldp holdtime-multiplier
This command configures the time-to-live (TTL) value sent in LLDP advertisements.
Use the no form to restore the default setting.
Syntax
lldp holdtime-multiplier value
no lldp holdtime-multiplier
value - Calculates the TTL in seconds based on
(holdtime-multiplier * refresh-interval)
≤ 65536
(Range: 2 - 10)
Default Setting
Holdtime multiplier: 4
TTL: 4*30 = 120 seconds
lldp medtlv
med-cap
Configures an LLDP-MED-enabled port to advertise its
Media Endpoint Device capabilities
IC 4-209
lldp medtlv
network-policy
Configures an LLDP-MED-enabled port to advertise its
network policy configuration
IC 4-209
show lldp config Shows LLDP configuration settings for all ports PE 4-210
show lldp info
local-device
Shows LLDP global and interface-specific configuration
settings for this device
PE 4-212
show lldp info
remote-device
Shows LLDP global and interface-specific configuration
settings for remote devices
PE 4-213
show lldp info
statistics
Shows statistical counters for all LLDP-enabled interfaces PE 4-213
Console(config)#lldp
Console(config)#
Table 4-57 LLDP Commands (Continued)
Command Function Mode Page