Samsung SPH-M920ZKASPR - Manual (Page 76)

62 2C. Settings
Vibrate
To set your device to vibrate for incoming calls and silent
for notifications:
ᮣ Press the volume button down in standby mode
until you see on the screen.
To set your device to always vibrate for incoming calls:
1. Press > and tap > Sound &
display .
2. Tap Phone vibrate . (If you have already checked the
option, tapping it again deselects the option.)
To set your device to vibrate while using the dialpad and
making onscreen selections:
1. Press > and tap > Sound &
display .
2. Tap Haptic feedback . (If you have already checked
the option, tapping it again deselects the option.)
Silence All
The Silence All option allows you to mute all sounds
without turning your device off (except for Media
volume).
To activate Silence All:
ᮣ Press and hold the volume button down in standby
mode until you see
on the screen.
To deactivate Silence All:
ᮣ Press the volume button up repeatedly to select a
volume level.
To set your device to silent mode:
1. Press > and tap > Sound &
display .
Note: By default, the Use incoming call volume for
notifications field is active, in this case, the Notification
slider is not accessible until it is disabled.
Tip: You can adjust the ringer volume in standby mode (or
the earpiece volume during a call) by using the volume
button on the left side of your device.
SPH-M920.book Page 62 Friday, October 8, 2010 2:17 PM