Ag Leader GPS 2100 Operators Manual - Manual (Page 9)

GPS 2000/2100 Setup
Ag Leader Technology
Apri1998 2-1
Overview The GPS 2000/2100 system can be used for various functions. This section
covers a few possible applications, but it is not comprehensive because the
user may discover applications that Ag Leader Technology has not
attempted or tested.
Initial Setup The following provides information on GPS 2000/2100 factory settings:
Operation Setting
Beacon selection The GPS 2000/2100 is set in Auto range mode. This
normally is acceptable, but if the user prefers to set the
receiver to a particular beacon, do the following:
Step Action
1 Set the unit in standard mode.
Note: Standard mode refers to the screen that
the GPS 2000/2100 starts up in after the power
has been turned on. This is the default screen.
2 Press the SETUP key until BEAC OPT is
above F3. Press F3.
3 Press F3 again to place the unit in Manual
mode.
4 Set the desired beacon frequency.
Refer to section 3, Operation, for more
information about making this change.
Satellite selection This option is available on the GPS 2100 only. If you
will be using the satellite differential option then do the
following depending on which service provider you
select:
Step Action
1 Set the unit in standard mode.
2 Press the SETUP key until SAT OPT is above
the F2 key. Press F2.
3 Press F1 to select Satellite differential.
4 If you will be
using…. Then …
OMNISTAR
Service Press the F2 key to select
the SAT SOURCE: that
covers your usage area best.
Call the OMNISTAR
subscription number