Ag Leader GPS 2100 Operators Manual - Manual (Page 28)

Operation GPS 2000/2100
Ag Leader Technology
April 1998 3-10
Screen options and
variables
Description
START Used to select the starting location for distance
measurements.
HOLD Freezes the screen display so that distances on the
screen can be recorded without the value changing
or fluctuating.
CLEAR Clears all current distance measurements.
QUIT Exits back to the main screen in MARK mode.
PT-PT DIST: and
TOT:
These two values represent a straight-line distance
from the start point that was chosen to the current
location of the antenna. Every time the user presses
START without clearing the memory the PT-PT
DIST: is reset but the PT-PT TOT: will display the
sum of the segments that have been marked.
PATH DIST: and
TOT:
These two values represent the actual path and
distance that the user has traveled from the start
point. The map on the screen represents this travel
distance. When START is selected again the DIST:
value will rest to zero and the TOT: value will add
the last segment into its running total.
The following describes how to use the Tape Measure feature:
Step Action
1 Set the unit in standard mode.
2 Press the MARK key.
3 Press the SETUP key until MEASURE is displayed above the F2
key. Press the F2 key.
4 The Tape Measure screen will now be displayed, and on the left side
of the screen a cursor will be flashing on the first digit of a number.
This value is the span for the map that will be displayed on the
screen. Use the arrow keys to change the value to the desired EW
span for the map. Once this is entered press the ENTER key.
5 Now the screen will ask the user to SET START USING ->. Press