Ag Leader GPS 2100 Operators Manual - Manual (Page 41)

GPS 2000/2100 Operation
Ag Leader Technology
Apri1998 3-23
Follow these steps to change the beacon selection mode:
Step Action
1 Set the unit to standard mode.
2 Press the SETUP key until BEAC OPT is above F3. Press F3.
3 To set the receiver in… Press…
Auto Range mode F1
Auto Power mode F2
Manual mode F3
If manual mode is selected…
Action
1 Use the up and down arrow keys to increment the
frequency number to the desired beacon frequency.
2 Press the left or right arrow keys to switch from CH0 ID:
to CH1 ID:.
3 Use the UP/DOWN arrow keys to enter in a frequency that
the channel will be set to.
4 Press the ENTER key when finished to activate the change.
RAD OPT
Select this option under the setup key to set the output for simulating a radar
gun. The user can set the pulses/ft value to either a custom value or select
one that will simulate a common brand of radar gun. This feature is not
related to the VTG NMEA message, but that message must be turned on for
the velocity option to function. This feature is intended for users that have
equipment that can accept a speed input from a radar gun. Call Ag Leader
Technology for more information and special cabling needed to use this
feature.