Ag leader technology – Ag Leader GPS 2100 Operators Manual User Manual
Page 30
Operation
GPS 2000/2100
Ag Leader Technology
April 1998
3-12
memory is filled:
Logging
Interval
(Seconds)
Time Left to Log
(Hours and
Minutes)
Logging
Interval
(Seconds)
Time Left to Log
(Hours and
Minutes)
1
1:05
11
11:55
2
2:10
12
13:00
3
3:15
13
14:05
4
4:20
14
15:10
5
5:25
15
16:15
6
6:30
16
17:20
7
7:35
17
18:25
8
8:40
18
19:30
9
9:45
19
20:35
10
10:50
20
21:40
Logging Data
Follow these steps to log data:
Step
Action
1
Press the MARK key to access mark mode. A cursor should flash on
the current field number.
2
Select the desired field number to log data in:
a)
Move the cursor to the digit in the field number that you want to
change by using the left or right arrow keys.
b)
After you select a digit to increment, use the up or down arrow
keys to change the value of the current digit.
Result: A corresponding data type should appear with the selected
field.
Example: To select F152, move the cursor to the left-most digit
and press the up arrow key once to change the number from 0 to 1.
Repeat this process for each digit until the desired number shows on
the screen.
3
After selecting the desired field and data type, press the left or right
arrow key until the cursor flashes next to LOG:. To begin logging
data internally, press either the up or down arrow key. To turn
logging off, press the up or down arrow key again.
Note: The unit will make audible beeps each time it logs a point.
The points will show up on mapping software as dots color coded by
elevation.