beautypg.com

Strip till control screen, Strip till control, Pplication – Ag Leader Versa Users Manual User Manual

Page 273: Trip

background image

259

A

PPLICATION

S

TRIP

T

ILL

Strip Till Control Screen

• Product Density
This density value (shown in pounds per cubic foot, or

lb./ft.3), is stored with each product. Press

to

edit value.

Note: For proper machine performance and accuracy. Product Density should be measured for every
application load.

• Conveyor 1 Rate
This setting represents the volume of product dispensed by one revolution of the conveyor drive shaft (cubic
foot per revolution, or ft.3 /rev.) This number is shown with the assumption that the conveyor shaft has a 1-
inch gate opening.

CAUTION: You must either manually enter conveyor rate value or perform a CFR calibration routine for
each product and channel combination, otherwise misapplication will occur.

• Static Calibration
Press the Static Calibration button to perform an automated routine to calibrate each metering circuit. This
calibration is performed before applying in field conditions. For more information, see

“Static CFR Calibration

Procedure for Hydraulic Drive systems” on page 259

.

• In-Field Calibration
Press the In-Field Calibration button to perform an automated routine to adjust the calibration number for
the selected metering circuit. This calibration is performed if there is a difference between the amount of
product logged as compared to what was actually applied. For more information, see

“In-Field Calibration

Procedure (Strip Till)” on page 261

.

Static CFR Calibration Procedure for Hydraulic Drive systems

You must perform a calibration for each granular product control channel (bin) for the equipment
configuration before applying in field conditions. This process is outlined below and on the following
page. The Static CFR Calibration Procedure performs an automated routine to calibrate each metering
circuit.

Press: Map button > Strip Till Control button > Static Calibration button

Channel 1

Channel 2

Channel 3

Prime

58 lb/ft

3

0.256 ft

3

/rev

DAP

Strip Till Control

Product

Density

Conveyor

Rate

Static

Calibration

In-Field

Calibration

3500

1

RPM

2

3

20

15

15

Static

Calibration