Ag Leader Versa Users Manual - Manual (Page 186)

172 Firmware Version 5.4
9. Assign Container Capacity
Press to enter the container capacity. Press to accept.
10. Enter Container Units
Use the drop-down menu to select the container units.
Once container has been configured press to continue.
11. Enter Swath Width
Press to enter swath width.
12. Enter Number of Boom Sections
Press / to enter number of boom sections.
13. Enter Boom Section Widths
Highlight specific boom section and press to enter boom width. The total width of all boom
sections must equal swath width.
14. Enter Application Point Offset
Press to enter distance from hitch to application point (front to back). Press to accept
value on offset screen. Press to accept value for the application point.
Note: If setting up a Self-Propelled Applicator, enter the distance from rear axle to application point.
Use drop-down menu to select distance Behind or In Front.
Note: At this point additional functionality can be added to the implement, such as direct injection.
If no additional functionality is being added, press to continue.
15. Add Additional Devices (optional)
Press to add boom control functionality.
16. Enter Hitch Point Offsets
Press check box if implement provides a hitch point. Press to enter distance and drop-down
menu to enter “to the left” or “to the right”. Press to enter distance Forward or Backward. Press
to continue.
17. Enter Implement Name
Press to enter a name for the implement. Press to continue.
18. Select Implement.
Press to continue.
19. Select Second Implement.
Use drop-down menu to select Implement or press to add second implement.
Norac UC5