Ag Leader Versa Users Manual - Manual (Page 272)

258 Firmware Version 5.4
The Start Prime button (A) begins the meter prime
routine and each meter shaft will rotate the number of
revolutions as defined on the Air Cart Prime Screen.
R
UN
T
IME
O
PERATIONS
During Run Time Operations, Strip Till operators can press the Strip Till Control
button to open the Strip Till Control screen. At this screen, you can adjust Product
Density, Conveyor Rate and other settings.
• Each of these settings described below must be set for each individual Product Channel (bin).
• The Product Density, and the Conveyor 1 Rate are all stored with each combination of product and
control channel.
S
TRIP
-T
ILL
(T
HREE
-B
IN
C
ONFIGURATION
)
• Strip Till Control button
Displays the status of the product control channel. The Meter Shaft Speed (in RPM) is shown underneath
the bin icon; the Fan Speed (also in RPM) is shown at bottom. When the fertilizer bin is grey no product
application is taking place. When product is being applied, the fertilizer bin icon changes color to green.
Press the Strip-Till Control button to display the Strip-Till Control screen and settings. These settings include
Product Density and Conveyor 1 Rate. For more information, see section beginning at
“Strip Till Control
Screen” on page 259 .
• Metering Indicator
The Metering Indicator is shown at the bottom of the Product Control Toolbox when the Map screen is
shown in Zoom to Extent. When the Map screen is shown in the Zoom Details view or Perspective View,
the metering indicator is shown as a bar that appears behind the vehicle icon.
100.00
50.00
50.00
100.00
DAP
MAP
4.09
ac lb/ac
lb/ac
4481
1 2
23 26
Start
Prime
1 2
14.0
mph
3
RPM
26
3500
1
RPM
2 3
20 15 15