Ag Leader Versa Users Manual - Manual (Page 251)

237
A
PPLICATION
S
PREADER
1. Press: Home button > Setup (wrench) button > Configuration (tractor) button > Product tab > Add (+)
button > Mix/Blend button
2. From the Type drop-down menu select Dry Blend
From the Define By drop-down menu select:
• Total amounts - to define blend by amounts going into the bin
• Rate/acre - to define blend by the amounts going on an acre
Press to continue.
3. From drop-drown menu select base units.
Press to continue.
4. Press to start the process of adding components to the blend.
Note: Any liquid herbicides set up within the system can be added to create an impregnated blend product.
5. Select the desired component from the drop-down menu.
More than 7 products can be put part of a Mix/Blend but only 7 or fewer can be active at the same time.
A new product can be set up at this time by pressing and following the Product Setup Wizard.
Press to add selected product or p ress to return to Add Mix/Blend screen without adding
a product.
6. Press to add an additional component.
7. When all components have been added press .
8. Enter Manufacturer name if applicable.
- Manufacturer name can be added to the drop-down menu by pressing
9. Press to enter a unique name for the blend.
Press to complete the process of setting up the dry blend or p ress to return to
Configuration Setup screen without adding a mix.
Created blend should appear under the Application heading located on the Product tab of the Configuration
Setup screen.
Represents Dry Blend prior to display firmware version 5.4 and mixes exported from SMS. Cannot be
edited by user.
New Dry Blend/Product Template created beginning with display firmware 5.4. Can be edited by
user.