Ag Leader Versa Users Manual - Manual (Page 21)

7
G
ENERAL
I
NST
A
LLATION
G ENERAL
I
NSTALLATION
D
ISPLAY
H
ARDWARE
• (A) USB media slot
Used for data transfer in and out of the display.
• (B) speaker
The built-in speaker is used for audible warnings. The
volume can be adjusted through the display setup routine.
• (C) RAM mount
• (D) Power/Reset switch
The Power/Reset switch is used for turning the display on
and off in installations where the system is connected to a
continuous power supply. If the display ever stops
responding, the manual power switch may be held in for five
seconds to restart the system. Only do this as a last resort,
data loss could occur during times of improper shutdown.
• (E) 28-pin auxiliary connection
Used for camera input.
• (F) 28-pin plug
The 28-Pin round connector contains CAN, RS-232 serial, and system power and ground connections. It is
compatible with other Ag Leader displays. Ethernet for ParaDyme and GeoSteer automated steering is
included in connection.
• (A) USB media slot
• Used for data transfer in and out of the display.
I
NSTALLATION
I
NSTRUCTIONS
All machine installation and mounting kits are shipped with instructions specific to that kit. Instructions
include special details relating to mounting, wiring and display configuration.
Mount the display to a secure support inside the vehicle cab. The following must be considered when
choosing a mounting location: