Adding non-hot-plug expansion boards, Adding non-hot plug expansion boards -20 – HP ProLiant DL760 Server User Manual

Page 94

4-20 Compaq ProLiant DL760 Servers User Guide

Compaq Confidential – Need to Know Required

Writer: Bryce Miller Project: Compaq ProLiant DL760 Servers User Guide Comments:

Part Number: 173774-001 File Name: e-ch4 Installing Hardware Options - Server Power Off.doc Last Saved On: 1/25/01 9:33 AM

Adding Non-Hot-Plug Expansion Boards

You can use non-hot-plug expansion boards in the ProLiant DL760 server, but
you must install them according to the following procedure. Prepare the server
by performing the following:

1. Back up your server data.

2. Shut down the operating system as directed in your operating system

instructions.

3. Power down the server.

4. Slide the I/O module out and open the top access panel.

To add an expansion board:

1. Open the top access panel.

2. Press on the top of the appropriate expansion slot release lever

and

open the lever toward the rear of the expansion slot

3. Remove the expansion slot cover

4. Open the air baffle

Figure 4-16. Preparing the hot-plug expansion slot for installation