HP ProLiant DL760 Server - Manual (Page 48)

2-14 Compaq ProLiant DL760 Servers User Guide
Compaq Confidential – Need to Know Required
Writer: Bryce Miller Project: Compaq ProLiant DL760 Servers User Guide Comments:
Part Number: 173774-001 File Name: c-ch2 Installing the Server in a Rack.doc Last Saved On: 1/24/01 4:46 PM
6. Open the air baffle
.
7. Loosen the shipping screw between the Processor and Memory Module
and the I/O module as shown in Figure 2-5 .
1
2
Figure 2-5. Loosening the shipping screw
Install any Expansion Boards or
Optional Features
The installation of any I/O expansion boards or other hardware options, such
as additional memory, can be done before mounting the server in the rack.
Refer to Chapter 4, “Installing Hardware Options – Server Power Off,” and
Chapter 5, “Installing Hardware Options – Hot Pluggable,” for more
information on installing hardware options and expansion boards.
Run the ROM-Based Setup Utility after you install certain hardware options,
with the exception of additional memory and most PCI/PCI-X boards.
NOTE: Refer to the Server Setup and Management pack shipped with your server to run
the ROM-Based Setup Utility. See Chapter 4, “Installing Hardware Options–Server Power
Off,” and Chapter 5, “Installing Hardware Options–Hot Pluggable,” to install many of the
major options.
NOTE: If the operating system is pre-installed on the server, refer to the Compaq Factory
Installed Operating System Software User Guide that is included with the server.