HP ProLiant DL760 Server - Manual (Page 22)

1-6 Compaq ProLiant DL760 Servers User Guide
Compaq Confidential – Need to Know Required
Writer: Bryce Miller Project: Compaq ProLiant DL760 Servers User Guide Comments:
Part Number: 173774-001 File Name: b-ch1 Server Features.doc Last Saved On: 1/24/01 4:43 PM
Expansion Slots
The server has eleven 64-bit I/O expansion slots that are spread over three
separate buses.
■ The Primary Bus (slots 7-9) will support PCI expansion boards at
33 MHz.
■ The Secondary Bus (slots 1-6) will support PCI expansion boards at
33 MHz or PCI-X expansion boards up to 50 MHz.
■ The Tertiary Bus (slots 10-11) will support PCI expansion boards up to
66 MHz or PCI-X expansion boards up to 100 MHz.
NOTE: Most expansion boards will work in any slot selected, but optimum performance is
obtained when expansion boards are grouped by capability and placed in buses together.
NOTE: Compaq recommends installing 100-MHz PCI-X expansion boards in the Tertiary
Bus, and 66-MHz PCI-X expansion boards in the Secondary Bus.
Network Controller
Supports a dual-port 10/100 TX UTP controller on the PCI local bus. Features
of the controller include two RJ-45 connectors for 10BaseT or 100TX
Ethernet. For information about the network controller, refer to the Compaq
website at
http://www.compaq.com
Redundant Network Controller (NIC) software, located on the Compaq
Support Software CD, supports a redundant NIC configuration. This feature
may be used with one dual-port, two dual-port, or two single-port NICs.
NOTE: When not using the dual-port capabilities, install the terminator plug from the
second RJ-45 connector.