HP ProLiant DL760 Server - Manual (Page 66)

Server Access 3-3
Compaq Confidential – Need to Know Required
Writer: Bryce Miller Project: Compaq ProLiant DL760 Servers User Guide Comments:
Part Number: 173774-001 File Name: d-ch3 Server Access.doc Last Saved On: 1/24/01 4:48 PM
The following sections provide instructions for removing the I/O module,
Processor and Memory Module, and Media module. For information
pertaining to PCI Hot Plug and hot-plug fan access, see Chapter 5, “Installing
Hardware Options - Hot Pluggable.”
CAUTION: Do not attempt to open any of the three modules while power is
applied to the system. They are not hot-pluggable. Immediate system shutdown
and loss of data will occur.
Accessing the I/O Module
To open the I/O module to install or replace hot-plug fans or hot-plug PCI
boards:
1. Slide the chassis out of the rack.
2. Lift the forward-most edges of the top access panel, as indicated by the
arrows in Figure 3-2, and slide it toward the front of the server.
Figure 3-2. Opening the top access panel
3. At this point, you can remove and replace the hot-plug fans and hot-plug
PCI boards as described in Chapter 5, “Installing Hardware Options -
Hot Pluggable.”