HP ProLiant DL760 Server - Manual (Page 80)

4-6 Compaq ProLiant DL760 Servers User Guide
Compaq Confidential – Need to Know Required
Writer: Bryce Miller Project: Compaq ProLiant DL760 Servers User Guide Comments:
Part Number: 173774-001 File Name: e-ch4 Installing Hardware Options - Server Power Off.doc Last Saved On: 1/25/01 9:33 AM
4. Rotate the ejector levers fully to unseat the processor terminator board
from the socket
. Remove the processor terminator board by pulling it
out by the handle
. Retain the board for future use.
NOTE: If you remove a Pentium III Xeon processor, the processor terminator board must
be reinstalled before powering up the server.
2
1
1
Figure 4-4. Removing the processor terminator board
5. Remove the memory board for easier access to the processor bus/core
ratio switch.
6. Locate the processor bus/core ratio switches for the processor buses. See
the beginning of this section or the access panel label for details.
7. Check the processor bus/core ratio switches of both processor buses to
ensure that the switches are in the default position (all switches OFF).
CAUTION: The server may not boot if the bus/core ratio switches are set to a
speed higher than the slowest processor. Failure to properly set the bus/core
ratio switches could cause damage to the server and could void your warranty.
Compaq recommends that the bus/core ratio switches remain in the default
position (all switches OFF).
NOTE: The Pentium III Xeon processor and Processor Power Modules are keyed to ensure
correct alignment.