HP Traffic Director sa7220 - Manual (Page 56)

C H A P T E R 3 HP Traffic Director Server Appliances User Guide
44
Boot Monitor
Commands Boot Monitor CLI commands (listed below) are described in this
chapter.
autoboot Enables or disables the Autoboot function. When Autoboot is
enabled, the SA8220 prompts you to press a key during restart to
enter the Boot Monitor command line interface. If you ignore the
prompt, restart finishes with the SA8220 in normal operating mode.
If Autoboot is disabled, the restart sequence ends by displaying the
Boot Monitor interface.
Example:
monitor> autoboot
Enable Autoboot? (yes,no) [yes] --->
boot Boots the device with a specific configuration. Variations on use of
the reboot command are described below.
Reboot with No Configuration Changes
1. Type the boot command.
The Boot Monitor displays the current configuration prompts
you for confirmation, as shown in the example below:
• autoboot • info
• boot • interface
• delete • ip
• dhcp • load
• dir • netmask
• dns • rich_bias
• dual • save
• factory_reset • settime
• failover • setup
• gateway • static_routes
• help • version
• host