HP Traffic Director sa7220 - Manual (Page 95)

C H A P T E R 4 Administration Screen
83
• Server Verification Interval: Edit this field to change the
interval in seconds at which servers are "pinged" to verify they
are available and able to handle traffic requests. (See "IRV" in the
Command Line Interface chapter). The valid range for this field
is 0 to 99999. A value of 0 disables IRV.
In addition to the above controls, the Settings tab also contains
the following read-only displays:
• System Name: Displays the name given the SA8220 in its initial
configuration.
• MAC Address: Displays the SA8220's Media Access Control
address.
• Status: The Status field displays information about the
SA8220's function and failover status. For more details about
status messages, please see “Status Information” in Chapter 2.
Software Tab The Software tab contains controls and displays allowing you to
perform the following tasks:
• Specify image category as either System software or Agent
Software (Agent software lists software components other than
the SA8220 system image that may be installed on the unit, such
as the HP Multi-Site Traffic Director Server Appliance SA9200
agent).
• View the list of currently installed system software images (the
SA8220 can have up to five system images installed).
• View the list of currently installed agent software images (the
SA8220 can have up to four agents installed in addition to those
accompanying each system software image).
• Specify which of the installed software images is to be active.
• Install or update software images.
• Delete software images.
• Enable or disable Passive FTP.
• FTP or TFTP new Multi-Site Agents to the SA8220.