HP Traffic Director sa7220 - Manual (Page 167)

C H A P T E R 5 CLI Commands
155
CLI
Commands The Command Line Interface commands are described below.
Command Description
config Changes the prompt to the CLI config branch.
config
config cli delete Deletes the specified user.
config cli delete
config cli info Shows all current CLI settings at this level.
config cli info
config cli login-attempts Specifies the maximum allowable number of failed login attempts
before closing the connection.
config cli login-attempts
where tries is a number from 1 to 30.
config cli more Sets scrolling of the output display to one page at a time or to
continuous display.
config cli more [enable | disable]
where:
•
enable allows you to scroll one page at a time.
• disable results in continuous scrolling.
config cli port
NOTE: If you are logged in
using telnet, do not use this
command. Doing so will
change the port parameters
and you will be
disconnected.
Specifies the telnet port on which the CLI runs.
config cli port
where port is a valid port. Valid ports are port 23 (the default) or
any unused port between 1024 and 65535.