Displaying snmp parameters – HP Traffic Director sa7220 User Manual
Page 255
C H A P T E R 7
Using SNMP
243
brokerCpsNormal
brokerConnCntAlert
brokerConnCntNormal
brokerCpuUtilAlert
brokerCpuUtilNormal
operationStateChanged
redundantBrokerDown
redundantBrokerUp
NOTE: This MIB is not
available on the SA7200.
hpl7-broker-mib.my
httpErrsToClientAlert
http606ErrsToClientAlert
NOTE: This MIB is
available only on the
SA8200/SA8220.
hpssl-acceleration-mib.my
sslTrafficOverflowAlert
hpuser-mib.my
operatorLogin
operatorLogout
Displaying
SNMP
Parameters
The GUI’s Administration-SNMP tab displays all SNMP parameters.
In the CLI, type this command to display all SNMP parameters:
show sys snmp info
Ensure that the SA8220’s IP Filtering security mechanism allows IP
access to SNMP, otherwise SNMP requests will not pass through the
filter.
Configuring
Community
Authentication
and Security
Parameters
The SA8220 SNMP supports community-based authentication. An
unlimited number of community strings can be configured for use by
the SA8220. Each community string can have read-only (ro) or read-
write (rw) privilege, and can be configured for use by a specific IP
address or all IP addresses. When the value any is used for
address> , the community string can be used by all IP addresses.