HP Traffic Director sa7220 - Manual (Page 47)

C H A P T E R 2 Serial Cable Failover
35
5. Save the Primary configuration.
monitor>save
List of currently saved configuration files(s).
You may save over an existing configuration file
or enter a new name.
File name
----------
active.cfg
backup.cfg
cris.cfg
‘active.cfg’ is the last booted configuration.
Enter configuration file name (- to cancel):
[active.cfg] --->
Configuration has been saved.
6. Boot the SA8220.
monitor>boot
Do you really want to continue boot? [y]
--->
Boot which configuration? [active.cfg]
--->
Please stand by, the system is being booted.
.... Done
Login>
Configure the Backup SA8220
1. Reboot the SA8220 that will be the Secondary and press a key at
the prompt to enter the Boot Monitor.
2. At the prompt, type the following command:
monitor>failover
3. Follow the prompts as listed below:
Specify failover method (disabled, serial,
route) [ ] --->s
Checking for failover unit...
Failover unit detected
--------------------------
Version : 2.3
Type : PRIMARY
State : ONLINE
Name : online13