HP Traffic Director sa7220 - Manual (Page 63)

C H A P T E R 3 Using the Boot Monitor CLI
51
failover Specifies the SA8220’s failover method. Three failover options are
available:
• disabled: no failover method will be used
• serial: serial cable failover will be used
• route: router failover will be used
Example:
monitor> failover
Specify failover method (disabled, serial,
route): [disabled] --->serial
Checking for failover unit...
Failover unit not detected or may not be
configured.
Is this machine Primary or Backup?
[Primary] --->
Enter the Network side Online IP Address
---> 10.6.3.200
Enter the Server side Online Address
---> 10.6.5.200
Enter the Network side Online hostname
--->net-onlinehost
Enter the Server side Online hostname
--->serv-onlinehost
Serial failover successfully configured
gateway Specifies the default gateway.
Example:
monitor>gateway
Enter default gateway: --->10.6.3.1
help Lists all Boot Monitor commands or optionally displays syntax for a
specified command.
Example:
gateway Set default gateway
interface Configure network interface card