HP Traffic Director sa7220 - Manual (Page 61)

C H A P T E R 3 Using the Boot Monitor CLI
49
dhcp Enables or disables the SA8220’s use of DHCP. When DHCP is
enabled, the SA8220 receives its configuration parameters from the
DHCP server at startup. When DHCP is disabled, the SA8220 ignores
the DHCP server, and so it must be manually configured at restart.
Respond to the prompt with
y to enable, or n to disable. DHCP is
disabled by default.
Example:
monitor> dhcp
Enable DHCP (yes, no)? [no] --->
dir Displays the list of saved boot configuration files.
dns Specifies the domain and (optionally) nameserver(s). The system
prompts you for the required information.
Example:
Would you like to configure DNS (yes, no)?
[no] --->
monitor>dns
Would you like to configure DNS (yes, no)?
[no] --->yes
Enter Domain name (‘-’ to cancel)
--->mydomain.com
Enter the IP Address of the Primary name server
(‘-’ to cancel) --->10.6.3.5
Specify additional name server
( to end ) --->10.6.3.10
Specify additional name server
( to end ) --->
dual Selects single or dual NIC operation.
Example:
monitor> dual
Enable dual NIC operation (yes, no) [no] --->